How to Install Metal Framed 3/4 Split Entrance Gates

Installing metal framed entrance gates is probably easier than you may think, and most inexperienced DIYers are capable of completing their own installation. There is a difference in the way we recommend fitting compared to a standard metal driveway gate (as seen below).

Rear View of Gate

Fitting a Metal Timber Entrance Gate

Because the majority of metal framed, timber cladded gates are fully boarded, its best to keep the gaps between the posts and the edge of the gate to a minimum. We recommend a 15mm gap each side and 10mm for centre opening gap.

  • First, a clearance is required between ground level and the bottom edge of gate. We recommend allowing 50mm (or 2") on a level drive although this may need to be increased if the driveway raises.The easiest way to do this is by using a straight edge (ie timber) and a level.
  • Next depends on whether there are posts/ pillars in place or not. If you need to fit posts, see "How to Fit Posts" for more info.

    On exisiting pillars or posts: As standard (if no posts are selected on order), you will receive 4 x hinge plates alongwith 4 x adjustable bolts that connects the gate to the plate.

    • Use one side of the gate and position it onto the straight edge. Put the silver threaded bar through the top (pre drilled) hole of gate frame (before this, make sure you remove one of the nuts off the threaded bar.)
    • Connect the bar to the hinge plate and mark the pillar/ post where the hinge plate needs to be mounted.

      Repeat this process for the bottom hinge plate but using a spirit level to ensure the gate is plumb then move on to opposite side. This stage needs to be accurate so spend time to get it right!

      • Using a hammer drill, drill the holes. Insert the wall plugs until they are flush with the surface. Fix the 4 hinge plates to the posts/ pillars.
      • Connect the four threaded bars to the gate frame and hang. Using the nuts, adjust untill the centre opening gap is approx 10mm. By adjusting either the top or bottom you can get the gates to be level with each other.
      • Once complete, put the gates into the closed position and release the two drop bolts (pre attached to gate) and mark the ground. Then, fully open the gates and mark where the drop bolts hit the ground. When happy with the position, drill the four holes. This will allow the gate to be secured in place if open or closed.

        Tools Required:

        • Spirit Level
        • Hammer Drill
        • Hammer
        • Spanner
        • Scewdriver
        • Pencil
        • Tape Measure